![]() Position the rip fence by releasing the locking lever on the front of the fence, which locks the fence into place, and then sliding it so its inner edge matches the desired width of the cut. A table saw blade spins towards you, from the top downward, so the sharp blades must face the front of the table saw and not the back. To do this, use the arbor nut wrench that came with your table saw to loosen the arbor nut (the nut that holds the blade in place) and position the rip blade with the teeth facing the front of the table saw. For example, if you’re ripping long pieces of wood from ½” plywood, set the blade no higher than ¾” above the tabletop. Adjust the blade height so the top of the blade rises no more than ¼” above the thickness of the material you’re cutting. Unplug the table saw and fit a rip blade (suitable for the material you’re cutting) into the blade arbor on the top of the table. Ripping is the simplest cut to make, thanks to the table saw’s rip fence that adjusts to the width of the desired cut and also serves as a guide to control the material while cutting. Below, you’ll find step-by-step directions for using a table saw to make each of these common cuts. Crosscutting applies to cutting material to a specific length. Ripping, the most common use of a table saw, involves cutting material to a specific width. With accessories such as clamps, stops, and jigs, you can make such specialty cuts as dado cuts, compound angles, and rabbet joints-yet woodworkers rely on the table saw most for two basic cuts. ![]() Also remember to unplug the saw before you adjust or align the blade, and don’t remove the safety guards that come with the saw. In addition to the specific safety observances to prevent kickback, take the time read the manufacturer’s safety provisions and be sure to always wear goggles and ear protection while using the table saw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |